m5.jpg

McNeilus M5™

A tough, nimble workhorse. Gets in—and out—of places the larger rear loader can’t. The McNeilus M5™ is perfect complement for fleets serving smaller routes or gated communities. The M5 11-yard is a full-featured vehicle, and shares many heavy- duty components with its big brothers. The M5 features the same high strength AR steel in the body, and comes standard with exclusive features like quick-change slide shoes and Pack-on-the-Go hydraulics. Check out the clean lines.

Description

The M5 Rear Loader is designed to be nimble and maneuverable in tighter places, perfect for serving smaller routes or tightly-packed communities.

The M5 features an 11-cubic-yard body and 2.5-cubic-yard hopper. The quick pack cycle time and pack-on-the-go hydraulics keep the hopper clear and help save time, especially on crowded streets. Count on this refuse truck to be one of the most productive and reliable for residential routes.

McNEILUS M5 SPECS-PERFOMANCE SHEET>> DOWNLOAD

Specifications
PERFORMANCE SPECIFICATIONS

WORKING RPM @ IDLE
Compaction Cycle 16 seconds
Sweep Extended
3 seconds
Sweep Retract
4 seconds
Slide Extend
5 seconds
Slide Retract
4 seconds
Ejector Extend (In seconds)
13 seconds
Ejector Retract (In seconds)
7 seconds
Tailgate Open
9 seconds
Tailgate Close 6 seconds
Compaction = 600-800 pounds per yard
*Cycle times may vary slightly

STANDARD BODY SPECIFICATIONS

Body Floor 10-gauge grade 50 high-strength steel
Side Walls 10-gauge grade 50 high-strength steel
Roof 10-gauge grade 50 high-strength steel
HOPPER SPECIFICATIONS
Hopper Capacity 2.5 cubic yards
Hopper Floor 1/4" AR200

PACKER/EJECTOR SPECIFICATIONS

Slide Face Plate 8-gauge A607 grade 50 high-strength steel
Sweep Face Plate 1/4" AR400
Side and Top Packing Panel 1/4' grade 50 high-strength steel
Quick change UHMW polyethylene slide shoes

TAILGATE SPECIFICATIONS

Lower Side Wall 3/16" AR200
Upper Side Wall 10-gauge grade 50 high-strength steel
Loading Edges 3/16" grade 50 high-strength steel
Tailgate Seal Height 50"

OPERATIONS

Mechanical controls with integrated control panel

HYDRAULICS

Pump Single Gear or Vane with Pack-on-the-Go flow control system
Control Valves Primary; Parker VA35 with Smark-Pak
Oil Reservoir (inside body) 35 gallons
Filter Parker 40 CN, 100 mesh suction strainer

CYLINDERS

Ejector Cylinder 5-1/4" bore x 3-3/4" rod x 63-1/4" stroke, telescopic
Slide Cylinder 3-3/4" bore x 2-1/4" rod x 33-1/2" stroke
Sweeo Cylinder 3 1/4" bore x 2 1/4" rod x 21-3/8" stroke
Tailgate Cylinder 3" bore x 2" rod x 20-7/8" stroke

PAINTING

Packer and components steel shot blasted prior to priming wit high solids epoxy primer

Back to: Rear Loaders